![]() You can recognize this by a missing pin next to pin 1 and 2. The red side of the cable should be put in pin 1 and 2 of the floppy disk drive. It’s important that you connect the cable correctly to the drive. Connect the floppy disk drive to the floppy drive controller via the floppy data cable (smallest adapter).Place the floppy drive controller on a non-conductive surface, e.g.Make sure that the red side of the data cable is on the same side of the USB (pic) ![]() Connect the floppy data cable to the floppy drive controller. ![]() !IMPORTANT! An internal floppy drive is an unstable source of power that can permanently damage the floppy drive controller, follow the correct order when connecting/disconnecting KryoFlux Step 1: Connect the internal floppy drive to workstation Kryoflux DTC (manual: Archivist’s Guide to Kryoflux) Workflow Currently I have no other disks to use, but that can be easily rectified.Digital Repair Cafe is a service of Automatisering Ingest Digitale Archieven (AIDA), operated by meemoo 3,5 inch Floppy Disks (SD or DD)įor 3,5 inch HD Floppy disks, follow the workflow with the USB floppy disk drive Hardware Floppy Disk Drive ModelĪll floppy drives with a floppy data cable The drive I am using is an IBM MPF82E USB Portable Diskette Drive, and the floppies themselves are Verbatim DataLife MF 2HD (IBM Formatted) disks. Here's an infodump, in case it will help: It could be the floppies, but I have no idea. I'm at a loss.ĭoes anyone have an idea of what the problem may be? I don't think it's the drive's fault, as it was stated that it had 3-mode support. I've tried formatting using the Windows utility itself, though it only allows for formatting to 1.44 MB. Using either of the FORMAT commands provided on the wiki page results in a "Parameters not compatible" error, and nothing happens. However, formatting the disk itself is where I encounter difficulty. The drive works fine, as do the floppies. Using the wiki guide for writing to 3.5 inch floppy disks, I ran through the necessary steps to format the disk accordingly. ![]() Recently I have gotten my hands on a 3-mode (advertised as supporting 720KB/1.25MB/1.44MB) USB floppy disk reader/writer and a couple of 3 inch floppies to attempt writing some X68k software onto, to find out if everything is working as it should. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |